Hot water is what you expect to come out once you turn your shower or sink on. But when there is no hot water, and you are forced to take a cold shower instead, it can be quite an unpleasant experience in many ways. The discomfort of the contact of the ice-cold water with your skin is the first thing that strikes you. Then, you begin to worry about whether there is a natural gas leak or your water heater has lost its energy efficiency. There can be many reasons behind your hot water system failing to provide you with the required hot water. In case your hot water system is not working, these are a few things that you need to check before calling up hot water service professionals.
Inspect the isolation valve:
In case you are unable to get any hot water from the taps, ensure that at least cold water is coming out. If at least cold water is being delivered properly, your hot water service system might be at fault. Look at the hot water system isolation valve. Generally, this is the red or yellow handle on one side of the water inflow area. In case you find that the valve is turned off, you have to only turn it on again.
In case there is no delivery of either hot or cold water, inspect the other taps as well and find out whether water is coming out of those. However, if no tap yields any water, inspect the main meter and find out whether the valve is in an activated state. In case the problem is noticed in a particular water fixture, ensure that the isolation valve is turned on, and is not in an off position.
Check the fuse box:
In the event that an electric hot water service system is there in your home, look at the fuse box that is marked for Hot Water. Ensure that it is properly functioning. Also, inspect the power cord connected to the hot water, and make sure that it is properly plugged in. Check whether the powerpoint is in an activated state. If you have a gas hot water system, find out whether the gas line has developed some problem or the gas bottle has insufficient gas.
Check the temperature settings:
In case you do not find the water to be sufficiently hot, look at the hot water service system temperature settings. You should allow it to have the temperature adjusted for 1 hour. Then, you should check again whether there is some change in the temperature of the water that is flowing out of the taps. Raise the temperature by adjusting the electric hot water system thermostat.
Identify the source of the leak:
Do you find any leakage of water from your hot water system? You have to find out where exactly the leak is in. During the heating cycle, it is quite normal to find a small quantity of water emanating from the temperature relief valve. However, in case there is too much water, such as a bucketful of water after a period of 24 hours, it is better that you give professional hot water service plumbers a call for a thorough inspection. You have to find:
- Whether there is a leak in the tank's bottom part or side area or
- Whether water is overflowing from the tank
No comments:
Post a Comment